FARGO DTC515 MANUAL PDF

FARGO Electronics DTC, DTC, DTC, DTC DTC color id printers, 10 Cleaning Cards, 10 Cleaning Pads, 10 cleaning tapes, full instructions. FARGO Electronics DTC, DTC, DTC, DTC DTC color id printers, DTC/ Dual hopper; PVC cards “); auto or manual feed. HID GLOBAL, HID, the HID logo, FARGO, and iCLASS, are .. installed and used in accordance with the instruction manual, may cause.

Author: Vilrajas Kitaxe
Country: Thailand
Language: English (Spanish)
Genre: Science
Published (Last): 15 August 2014
Pages: 374
PDF File Size: 4.61 Mb
ePub File Size: 12.20 Mb
ISBN: 710-5-45174-672-1
Downloads: 94541
Price: Free* [*Free Regsitration Required]
Uploader: Voodoobei

Extra Card Cleaning Cartridge fully assembled with tape for easy loading.

mankal Page 86 – Resolving the poor Image Quality problem Repeat Steps 1 to 6 above until the Test Image is correctly positioned or Ribbon wrinkle is alleviated. See the next page. Changing The Hopper Settings below the Hopper for exception cards to be inserted. Replacing The Main Board d Along the left edge of the circuit board, remove the two 2 mounting screws at the middle and lower section.

Fargo DTC500 Specifications

Note that the card grid lines are spaced at. If the card is bowing downward, the reverse bending pressure may be too great.

When segmenting track data, the appropriate Field Separator FS must mwnual used. Ribbon panel is printed or passes beneath the Printhead. Ribbons may be ordered individually, or in a case of This is the discharge end of the Printer. Disconnect the cable connector. Open the program and type in: For most applications, the default settings for these options do not need to be changed.

  ASKEP APPENDICITIS PDF

FARGO Electronics DTC, DTC, DTC, DTC DTC color id printers

It can only be seen when you hold the Printhead, as shown here. Record the Magnetic TOF value on the test card last printed. Do not reverse the overlaminate roll.

Using The Magnetic Track Selection Option After making the required selection, the Magnetic Track options box displays the current set of customization options for the selected track. Use a double-shielded parallel cable no longer than six feet in length.

Replace the Main Board. Along the left edge of the circuit board, remove the two 2 mounting screws at the middle and lower section. Resolving the incomplete Resin Printing problems continued See the previous procedure in this section.

Replacing The Main Board d 3 Circuit Board mounting screws located at the left, middle and right sections. Viewing The Report Supplies Press the Reset button to clear the entire existing error log and start a new log.

  KABALEVSKY OP 38 PDF

The following describes these options and the Printer’s magnetic encoding process. Determine if the error repeats itself after replacing the Main Board.

Damage may occur to the lamination Roller!

FARGO DTC SPECIFICATIONS Pdf Download.

Ethernet Interface Adapter Windows frgo. Close the lamination module. If the Headlift Sensor is failing, replace it. Change the Prox Setting from None to Installed. As an alternative to replacing the Main Print Board, the chip U17 can be replaced.

Page 17 Switch Box or the peripheral.

Close the Print and Transfer Stations after the Rollers are clean and completely dry. Step Procedure Select this option to ensure no print data will be sent to the Printer while all encoding instructions will be sent according to how they are configured within the software.

FARGO Electronics DTC500 Series Troubleshooting Manual

Use mwnual Torx T Screwdriver to remove the two screws. Select Setup Printer and Encoder Settings. There should be sufficient resistance to prevent the card from slipping from the Flipper table.