ASTM International E Standard Test Method for Water Penetration of Exterior Metal Roof Panel Systems by Uniform Static Air Pressure Difference. ASTM E(). Standard Test Method for Water Penetration of Exterior Metal Roof Panel Systems by Uniform Static Air Pressure. ASTM E is the standard test method for water penetration of exterior metal roof panels by uniform static air pressure difference. The ASTM E test.

Author: Mugal Gugul
Country: Angola
Language: English (Spanish)
Genre: Environment
Published (Last): 4 May 2016
Pages: 130
PDF File Size: 8.77 Mb
ePub File Size: 17.27 Mb
ISBN: 647-2-52439-919-4
Downloads: 36521
Price: Free* [*Free Regsitration Required]
Uploader: Fenrit

The preload test pressure differences positive and negative are to be specified. Pre-loading is a essential part of the testing procedure.

Read more about what our customers have to say In service, the performance also depends on the rigidity of supporting construction, roof slope, and on the resistance of components to deterioration by various causes: This e1664 method is a specialized adaption of Test Method E It is difficult aatm simulate the identical complex wetting conditions that can be encountered in service, including large wind-blown water drops, increasing water drop impact pressures with increasing wind velocity, and lateral or upward moving air and water.

The positive test pressure shall be greater than or equal to 15 pounds per square foot. These notes and footnotes shall not be considered as requirements of the test method. This process is repeated for a total of three cycles. These factors shall be fully considered prior to specifying the test pressure difference. The test is conducted by attaching the chamber to the astj specimen.


The purpose of this test method is to conduct quality assurance water penetration testing of the roof including panel side laps and structural connections.

Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are asttm considered standard.

A roof contains many details. Link to Active This link will always route to the current Active version of the standard. This is a test procedure. Composite systems in which the source cannot be readily determined are outside the scope of this test method.

SITC has utilized this test method to assist our clients with their quality assurance testing of metal panel roof systems.

Practical considerations suggest that every combination of panel thickness, span, and design load need not be tested in order to substantiate product performance. It does not include leakage at openings or perimeter or any other details. The slope of the roof is significant.

For specific hazard statements, see 7. In applying the results of tests by this method, note that the performance of a roof or its components, or both, may be a function of proper installation and adjustment.


ASTM E – Farabaugh Engineering and Testing

After e16446 the preload there is a two minute recovery period. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

Historical Version s – view previous versions of standard. The calibrated spray racks shall deliver water uniformly against the roof surface at a minimum rate of five gallons per square foot per hour. Some designs are more sensitive than others to this upward moving water. Then the s1646 is preloaded with a negative static air pressure differential for a minimum of 10 seconds.

ASTM E1646

This test method shall not, by itself, be relied upon to form conclusions about overall water penetration through metal roofs. A section of calibrated spray racks are set in place 12 inches asm the specimen.

Prior to testing a positive static air pressure differential preload is applied. For that reason the slope of the roof plays a significant importance. Although prescribed modifications are outside the scope of this test method, an experienced testing engineer is able to use the principles presented in this test method and generate significant data by isolating specific details and measuring leakage.